WATERPROOF, DUSTPROOF & SHOCKPROOF!
The Trident Mod by Vandy Vape is a waterproof vape mod with silica gel surface. The mod is equipped with PCB board and has multiple protections to avoid potential risks. Powered by a single 18650 battery, the Trident can reach up to 100W.
- IP67 Waterproof.
- Silica gel surface brings you a perfect grip.
- Equipped with PCB board.
- Single 18650 battery (Battery Not Included).
WATERPROOF – Silica gel material, IP67 waterproof extreme water, shock, and dust protections. Free from worry of rain damage or dropping it by accident.
INTELLIGENT LED DISPLAY, SHOWING CLEAR BATTERY POWER – The Trident Kit has LED display that shows you the exact battery power condition. When you start vaping, the current light gets brighter; the MOS tube controls output; the non-smoking LED is gradually extinguished when you stop vaping, and the MOS stops outputting. The three indicator colors on the switch button represent the various battery capacity.
- Purple Light: ≥ 70% battery capacity ( > 3.66V)
- Blue Light: ≥ 30-70% battery capacity ( > 3.48V)
- Red Light > 30% battery capacity ( < 3.48V)
- The Red Light will also flash 5 times once the voltage drops below 2.8V.
MULTIPLE PROTECTIONS – Provided to avoid potential risks including over-heating protection, short-circuit protection, battery management system, and a 10 second cut-off.
- Size: 92mm x 27mm
- Output Power: <100W
- Working Voltage: 3.2-4.2V
- Working Current: <35A
- Output Voltage: 2.8-4.0V
- Coil Resistance Range: 0.1-3Ω
- Output Mode: Bypass
- Standby Current: ≤ 10uA
- G.W. (including package): 298g
BATTERY INSTALLATION – Open the battery cover by rotating on the bottom of the mod. Install one 18650 battery into the device according to the correct directions. Twist the battery cover back on.
- 1 x Trident Mod
- 1 x User Manual